User manual

User Manual
Page 8 of 38
Configuring the Repeater
Setting up the device is easy. Follow the steps below to configure the device for your current wireless router/AP.
Ensure to disable the wireless connection on the PC or laptop used for configuring the WR300N. Please note that
the main router/AP and Wireless Repeater must be on the same wireless channel.
To configure your device via the Web GUI:
1. Connect the WR300N to a power outlet.
2. Connect an Ethernet cable from your PC’s Ethernet port to the Ethernet port at the base of the WR300N.
3. Once a connection to the WR300N is established, your PC/laptop will receive an IP address and you can
start the configuration using the web graphical user interface.
4. To access the web GUI, Launch your web browser and input 10.0.10.254 on the address bar.