User manual

User Manual
Page 13 of 38
Configure the WR300N as a Wireless AP
Use the WR300N as a Wireless Access Point to turn a regular modem-router into a wireless capable networking
device to connect wireless-enabled devices such as laptops and smart phones.
To setup the device as a wireless AP:
1. Connect a PC/laptop to the Wireless Repeater. Plug an Ethernet cable to the Ethernet port at the base
portion of the device.
2. Once a connection to the device is established, your PC/laptop will receive an IP address and you can
start the configuration using the web graphical user interface.
3. To access the web GUI, Launch your web browser and input 10.0.10.254 on the address bar.
4. Input username as admin and password as admin. Click the OK button.
5. Click on the Manual Setup button and enter the SSID, security type, encryption type and WEP/passphrase
for your Wireless Access Point, then click the Apply button.
6. After the settings are applied, unplug the Ethernet cable from your PC and connect it to an available
Ethernet port in your modem-router to match the hardware setup illustrated below.