User`s guide

17
5
REMOVING YOUR DIAMOND PRODUCT
This section describes how to properly remove your Viper software and hardware
from your system should you need to do so.
♦ REMOVING VIPER V700 SERIES UNDER WINDOWS 98/95
♦ REMOVING VIPER V700 SERIES UNDER WINDOWS NT 4.0
♦ REMOVING DIAMOND SOFTWARE TOOLS
REMOVING VIPER V700 SERIES UNDER WINDOWS 98/95
1. From the Start menu, go to Start > Settings> Control Panel, then double-click
on Display. The Display Properties sheet appears.
2.
Click on the Settings tab, then press the Advanced Properties button.
3.
Click on the Adapter tab, the press the Change button. The Select Device window
appears.
4.
Click on the Show All Devices bullet. Under Manufacturers select Standard
Display Types. Under Models, select Standard Display Adapter (VGA).
5.
Click on Apply, then click on OK in all windows to close and accept the changes.
To remove the hardware:
1.
Shut down your computer.
2.
Remove the computer case as outlined in the hardware installation instructions in
Chapter 2.
3.
Ground yourself by touching the power supply box.
To remove the hardware, simply reverse the hardware installation procedures from
Chapter 3.