Troubleshooting guide



6 Navi

atin

the Monitor

6.1 Navigating the Monitor On-screen Display(OSD)

The DX-D193P TFT-LCD Security Monitor has several modes: Composite1/2, YPbPr, VGA, DVI and

S-Video.

The LCD monitor is programmed through the on-screen display (OSD) menus and submenus where an

operator can select operating parameters. To access the OSD menus, press the Menu button on the front

panel. Use the front panel of the monitor to make any necessary adjustments to the OSD.

NOTE: When you are navigating through the OSD menus, use the MENU button to select a menu or exit

a menu.

To navigate the set up menus, follow the steps below:

1. Connect the CVBS or VGA cable.

2. Press the POWER button to turn on the unit (see Figure 3.1).

3. If required, press the SOURCE button until a signal is displayed. NOTE: Main menus are not

available without a signal applied.

4. Press the MENU button to activate the main menu selections (see Figure 3.1).

5. Press the

and buttons to select a menu.

6. Press the ＋ and

－

buttons to toggle the OSD values directly.

7. Press the MENU button to exit the OSD menu bar.

6.2 On-screen Display Menus

There are on-screen menus that allow you to customize your settings. Press the MENU button to access

the OSD menu.