Specifications

13
8. Select H-Position or V-Position and press AUTO.
Adjust the horizontal and vertical position so that the image is centred.
Its width and height should be the same as the visible width of the screen.
Close this submenu by pressing MENU.
9. Press MENU to close the OSD menu and save your changes.
If you are still not satisfied with the result, check the videocard is set to
native resolution the refresh rate is set to 60Hz, before repeating this
procedure.
Please Note:
You must use one of the factory modes. If the Auto button is not working, or the
NO SUPPORT message is shown on the OSD, you are not using a supported
resolution. If you are having difficulties selecting a supported mode, ask your
computer dealer, or the manufacturer of your graphics card for assistance.
The procedures described in this chapter should be performed for every
resolution and type of graphics signal that you wish to use. For example, if a
particular application requires a resolution of 800 x 600 pixels, but all other
applications use the monitor’s native resolution, you will need to display the
test pattern and make adjustments twice.
The monitor will remember your settings and use them whenever you turn the
monitor on. Note that you may need to re-adjust the monitor if it is connected to
a different computer or if the videocard is replaced.