User's Manual

90
The keyboard controller test failed. You may have to replace your
keyboard or keyboard controller but may be able to use an external
keyboard.
• Keyboard error
Keyboard not working. You may have to replace your keyboard or
keyboard controller but may be able to use an external keyboard.
• Keyboard error nn
BIOS discovered a stuck key and displays the scan code for the stuck
key. You may have to replace your keyboard but may be able to use an
external keyboard.
• Monitor type does not match CMOS - Run SETUP
Monitor type not correctly identified in Setup. This error probably
means your BIOS is corrupted, run the setup utility and set all settings
to the default conditions.
• Operating system not found
Operating system cannot be located on either drive C or CD-ROM
Enter the setup utility and see if both the fixed disk and CD-ROM are
properly identified and that the boot sequence is set correctly. Unless
you have changed your installation greatly, the operating system
should be on drive C. If the setup utility is correctly set, your hard drive
may be corrupted.
• Parity Check 1 nnnn
Parity error found in the system bus. BIOS attempts to locate the
address and display it on the screen. If it cannot locate the address, it
displays ????. This is a potentially data destroying failure.
• Parity Check 2 nnnn
Parity error found in the I/O bus. BIOS attempts to locate the address
and display it on the screen. If it cannot locate the address, it displays
????. This is a potentially data-destroying failure.
• Press <F1> to resume, <F2> to SETUP
Displayed after any recoverable error message. Press the [F1] key to
continue the boot process or the [F2] key to enter Setup and change
any settings.