Dialogic® IMG 1004 Integrated Media Gateway Quick Start Guide Release 10.3.x / 10.5.x Dialogic Corporation www.dialogic.
IMG 1004 Quick Start Guide Copyright and Legal Notice Copyright © 2005-2008 Dialogic Corporation. All Rights Reserved. You may not reproduce this document in whole or in part without permission in writing from Dialogic Corporation at the address provided below. All contents of this document are furnished for informational use only and are subject to change without notice and do not represent a commitment on the part of Dialogic Corporation or its subsidiaries (“Dialogic”).
IMG 1004 Quick Start Guide Hardware Limited Warranty Warranty for Hardware Products: Dialogic Corporation or its subsidiary that originally sold the hardware product ("Dialogic") warrants to the original purchaser of this hardware product, that at the time of delivery the hardware product supplied hereunder will be free from defects in material and workmanship. This warranty is for the standard period set out on Dialogic's website at http://www.dialogic.
IMG 1004 Quick Start Guide Quick Start Guide Overview - IMG 1004 Topic Location: IMG1004-Quick Start Guide Overview This IMG 1004 Quick Start Guide is an abbreviated guide which explains how to connect power and network cabling. For more information on setup please either refer to the “IMG 1004-Installation and Setup Guide” on the Technical Publications CD supplied or go to the Dialogic Technical Support website at http://www.dialogic.
IMG 1004 Quick Start Guide Connecting and Configuring Network Management Port ‘CTRL’ The information below will provide the user with a basic setup sequence for connecting and configuring the IMG 1004 along with the GCEMS server to download system software and start configuring the IMG 1004 using the ClientView GUI. On the rear of the IMG 1004 are the network interfaces. The first interface -CTRL- is a Fast Ethernet port which is dedicated to network management and VoIP signaling.
IMG 1004 Quick Start Guide GCEMS software installation. The GCEMS Server will need the most current system software in order to configure and provision the IMG 1004. The most current software can be obtained from the Dialogic Technical Support website. 1. Go to the Dialogic Technical Support Website at http://www.dialogic.com/support 2. Logon and go to the BBS Software download site. As noted above, a support contract with Dialogic is needed to access this site.
IMG 1004 Quick Start Guide SS7 links are brought in over the Bearer Ports Starting ClientView to start Configuring Switch Once the IMG 1004 has software installed, the cabling is connected, and the GCEMS server has been configured then the ClientView application can be used to configure the IMG 1004.