Programming instructions

14 Integration Technical Note
©June 2003 Ericsson Enterprise AB MITEL D/82 Station Set Emulation
EN/LZT 108 6655 R1A
Programming Dialogic Configuration Manager
Programming Dialogic Configuration ManagerProgramming Dialogic Configuration Manager
Programming Dialogic Configuration Manager
By default, the Dialogic Configuration Manager for software version SR5.01.2
sets the parameter PBXSwitch type to Nortel_Norstar. This parameter must be
changed to the appropriate PBX type you are integrating with OneBox. Follow
these steps to change the parameter for each D/82JCT-U linecard installed:
1. Click Start, point to Programs, point to Dialogic System Software, and
select Dialogic Configuration Manager-DCM.
2. Stop the Dialogic service if it is running.
3. Double-click the installed D/82U linecard to open the Properties sheet.
4. On the Miscellaneous tab, select the PBXSwitch parameter.
5. In the Values list, select MITEL_DNIC_M430 as the PBXSwitch type.
6. On the Telephony Bus tab, verify that the correct PCM encoding scheme is
selected. The default value is automatic or U-Law; you must change this
value to A-Law outside of the U.S. and Japan.
7. Click OK.
8. Repeat steps 3-7 for each D/82 linecard that is installed.
9. Restart the Dialogic service and close Dialogic Configuration Manager.