Programming instructions

12 Integration Technical Note
©June 2003 Ericsson Enterprise AB MITEL D/82 Station Set Emulation
EN/LZT 108 6655 R1A
Subscriber Telephone Programming
Subscriber telephones can be programmed at the telephone to forward to
OneBox. If the automated attendant application will use monitored transfers,
program FORWARD-NO ANSWER on subscriber telephones. If the
application will use blind transfers, program FORWARD-BUSY/RNA on
subscriber telephones.
As an alternate method of programming for subscriber stations, build a call re-
routing table. This method will allow subscribers to change forwarding to a
different target. Also, the programming will not be lost in the event of a power
failure.
1. In the Call Rerouting First Alternative Assignment Form (CAL R F), assign
the OneBox hunt group pilot as the first alternative. Specify Busy, DND, and
RNA if you will be using blind transfers. Assign them to reroute on CO
lines, internal, DID, and TIE lines if applicable.
2. In the Call Rerouting Assignment Form (CAL R AS), assign subscriber
stations to the First Alternative.