User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 348
Dialogic Corporation
For further information about this feature, see Section 1.57, “Mixing ISDN and CAS on
Dialogic
®
DM/V-B Boards”, on page 225 of this Release Update.
Update for new PDK Configuration Property Sheet
Because of a new feature in the Service Update, a new PDK Configuration property
sheet in DCM is now used to assign country dependent parameter (CDP) file variants
to trunks that use CAS or R2MF protocols. Information about this property sheet
should be added to Chapter 4, Configuration Procedures, following Section 4.4,
Selecting a Configuration File Set. The new property sheet should also be
documented in Chapter 5, DCM Parameter Reference. For further information about
the new property sheet, see Section 1.35.1, “PDK Configuration Property Sheet”, on
page 105 of this Release Update.
Update to Section 4.5, Setting the TDM Bus Clock Source (PTR# 30175)
The following note is added to Section 4.5, Setting the TDM Bus Clock Source:
Note: When configuring a board that has front-end capability as resource only, the system will not detect
this and might select this board as a clock master. In this event, the user must manually configure
another board in the system as the clock master.
Updates to Section 5.5, Physical Property Sheet
The following description of the DCM parameter PhysicalSlotNumber should be
added:
PhysicalSlotNumber (PCI Boards)
Description: The PhysicalSlotNumber parameter specifies a PCI board’s rotary-switch setting.
The rotary-switch setting for Dialogic
®
DM3 PCI boards can be the same for all boards in the
system if the value is set to 0.
Values: 0 to 15
Guidelines: Use the PhysicalSlotNumber parameter default value.
The description of the DCM parameter PciID should be replaced by the following:
Group 1 Group 2
4ESS (T1) DPNSS
5ESS (T1) DASS2
NTT (T1)
NI2 (T1)
DMS (T1)
QSIGT1 (T1)
QSIGE1 (E1)
NET5 (E1)
T1CC (T1)
CAS (T1)
E1CC (E1)
R2MF (E1)