User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 110
Dialogic Corporation
When in clear channel mode, the time slot 16 mapping is as follows:
• NI TS1-NI TS15 map to dtiB1T-dtiB1T15
• NI TS17-NI TS31 map to dtiB1T16-dtiB1T30
• NI TS16 maps to dtiB1T31
Note: The application should expect a GCEV_UNBLOCKED event when gc_open( ) is called
on trunks set for clear channel.
1.38.2 Configuring the Software
In the CONFIG file, the Signaling Type parameter (0x1602) allows you to configure a
trunk for ISDN or clear channel. All trunks are set to Net5 by default. To switch a trunk to
clear channel, the SignalingType parameter should be changed to 6 (Clear) in the
[lineAdmin] section for that trunk in the CONFIG file. All CONFIG file parameters are
described in detail in the Dialogic
®
DM3 Architecture PCI Products on Windows
®
Configuration Guide.
The new configuration files can be selected by using the Dialogic
®
Configuration Manager
(DCM). This procedure, which must be performed before the boards are started, is also
described in the Dialogic
®
DM3 Architecture PCI Products on Windows
®
Configuration
Guide.
1.38.3 Documentation
The online bookshelf provided with Dialogic
®
System Release 6.0 PCI for Windows
®
contains information about all system release features including features for application
development, configuration, administration, and diagnostics.
For detailed information about configuring Dialogic
®
DM3 Boards, see the Dialogic
®
DM3
Architecture PCI Products on Windows
®
Configuration Guide.
Note: The online bookshelf has not been updated for this feature, so the Dialogic
®
DM3
Architecture PCI Products on Windows
®
Configuration Guide does not currently include
information about these new configuration files.
1.39 Detection of Unsupported Boards
With the Service Update, if an unsupported board (i.e., a board that is not supported in
Dialogic
®
System Release 6.0 PCI for Windows
®
) is detected by the software, an error
message about the unsupported board will appear in a log file in dialogic/log directory with
the following filename rtf*.txt (for example, rtflog-10072005-14h47m25.639s.txt). System
Release 6.0 PCI Windows will not prevent you from installing an unsupported board.
However, the Dialogic
®
Configuration Manager (DCM) will not show any unsupported
boards.