User`s guide

ManualsBrandsDialogic ManualsComputer HardwareM7324

38 Dialogic

®

1000 and 2000 Media Gateway Series Getting Started Guide

Dialogic Corporation

Installation

3. Press the Enter key repeatedly until the following prompt appears:

PIMG>

4. At the prompt, type pwd and press Enter.

5. When prompted, enter the password for the admin user (the default is IpodAdmin) and press

Enter.

6. At the prompt, type quickcfg and press Enter.

7. You will then be prompted to enter the following parameter information:

• Client IP Address (See Client IP Address parameter information in the “Parameter

Reference” section of the User’s Guide.)

• Client Subnet Mask (See Client Subnet Mask parameter information in the “Parameter

Reference” section of the User’s Guide.)

• Network Gateway IP (if required) (See Default Network Gateway Address parameter

information in the “Parameter Reference” section of the User’s Guide.)

• Select Operating Mode (See Operating Mode parameter information in the “Parameter

Reference” section of the User’s Guide.)

• Select PBX Type (See PBX Type (DMG1000 Only) parameter information in the

“Parameter Reference” section of the User’s Guide.)

• Select T1/E1 Line Mode (DMG2000 only) parameter information in the “Parameter

Reference” section of the User’s Guide.)

• Select T1/E1 Protocol (DMG2000 only) parameter information in the “Parameter

Reference” section of the User’s Guide.)

8. When prompted that the parameters have been successfully configured, type restart at the

PIMG> prompt to restart the Media Gateway unit.

You should now be able to connect to the Media Gateway unit from the Web interface using

the newly configured IP Address.

4.4 Basic Configuration via the IP Interface (All Models)

Each Media Gateway unit is initially configured with a default IP address of 10.12.13.74. This

allows the unit to be configured using a Web browser by pointing the Web browser to the default

IP address.

Caution: Because all Media Gateway units use the same default IP address, you should connect them one at

a time to avoid IP address conflicts when configuring a system with multiple Media Gateways.