User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series Getting Started Guide 19
Dialogic Corporation
Controls, Indicators, and Connectors
1.2.5 TX/RX/FULL/100 Indicators
The LED indicators on the rear panel provide the following information:
• The TX indicator blinks when data is transmitted across the Ethernet interface.
• The RX indicator blinks when data is received on the Ethernet interface (even data that is not
intended for the DMG1000).
• The FULL indicator lights to show that the Ethernet is connected to the network in full duplex
mode.
• The 100 indicator lights to show that the Ethernet interface is connected to the network at 100
Mbps.
1.2.6 RESET Switch
The RESET switch allows you to restart the DMG1000 Unit. Restarting is necessary to cause
changes to specific parameters to take effect.
1.3 Front Panel Indicators for DMG2000 Models
The front panel LED indicators, Figure 3, include:
1. READY Indicator
2. DATA Indicator
3. LAN STATUS 1 and 2 Indicators
4. T1/E1 STATUS Indicators
Figure 3. Front Panel - DMG2000 Models
1.3.1 READY Indicator
The READY indicator is a multicolored LED that shows the unit’s system status, where:
• Unlit - indicates that the unit is not powered on.
• Steady Red - indicates that the unit is in the power-on initialization stage.
• Steady Green - indicates that power-on initialization is complete and the unit is awaiting
application load.
• Flashing Green - indicates that the application initialization process has completed and that
the unit is active.
READY
DATA
1
2
LAN STATUS
T1/E1 STATUS
ALARM
LINK
1
2
3
4