Dialogic® IMG 1010 Integrated Media Gateway IMG 1010 Module Install Instructions Release 10.3.x / 10.5.x Dialogic Corporation www.dialogic.
® Installing a Dialogic 1010 VoIP or Media Module Copyright and Legal Notice Copyright © 2005-2008 Dialogic Corporation. All Rights Reserved. You may not reproduce this document in whole or in part without permission in writing from Dialogic Corporation at the address provided below. All contents of this document are furnished for informational use only and are subject to change without notice and do not represent a commitment on the part of Dialogic Corporation or its subsidiaries (“Dialogic”).
® Installing a Dialogic 1010 VoIP or Media Module Hardware Limited Warranty Warranty for Hardware Products: Dialogic Corporation or its subsidiary that originally sold the hardware product ("Dialogic") warrants to the original purchaser of this hardware product, that at the time of delivery the hardware product supplied hereunder will be free from defects in material and workmanship. This warranty is for the standard period set out on Dialogic's website at http://www.dialogic.
® Installing a Dialogic 1010 VoIP or Media Module Installing a Dialogic® IMG 1010 VoIP or Media Module to Dialogic® IMG 1010 Integrated Media Gateway. Caution: Electrostatic Discharge Protection (EDP) must always be used. Electrostatic Discharge (ESD) protective straps, shoes, or mats must be used when working with electronic components. Electrostatic discharge from your body can damage integrated circuits during installation.
® Installing a Dialogic 1010 VoIP or Media Module 4. Re-insert Dialogic® IMG 1010 Motherboard Tray. Align the rail on each side of the tray with the guides on the inside of the docking station. 5. Verify the ejectors are in the up position. 6. Slide the tray in until the power connectors and signal connectors initially mate (the ejectors will start to move down). Cautions: Do not force the tray if any resistance occurs when mating with the docking station. Using undue force could damage the unit.
® Installing a Dialogic 1010 VoIP or Media Module Diagram 2 - Module Positions Important: If only one Dialogic® IMG 1010 VoIP Module is to be installed, it must be at Position 0. See illustration below.
