Dialogic® IMG 1004 Integrated Media Gateway Quick Start Guide March 2010 07-8724-02 www.dialogic.
Copyright and legal notices Copyright © 2005-2010 Dialogic Corporation. All Rights Reserved. You may not reproduce this document in whole or in part without permission in writing from Dialogic Corporation at the address provided below. All contents of this document are furnished for informational use only and are subject to change without notice and do not represent a commitment on the part of Dialogic Corporation or its subsidiaries (“Dialogic”).
Table Of Contents Table of Contents Revision history ..................................................................................................... iv Overview ................................................................................................................ 5 Shipping Information ............................................................................................... 5 Connecting AC Power ..........................................................................................
Revision history Revision Release date Notes 07-8754-02 April 2009 N/A Last modified: 03/10/2010 Refer to http://www.dialogic.com for product updates and for information about support policies, warranty information, and service offerings.
Index Overview This IMG 1004 Quick Start Guide is an abbreviated guide which explains how to connect power and network cabling. For more information on installation and setup, please reference the online documentation at http://www.dialogic.com/manuals. Note: To access the Dialogic Technical Support website, a support contract with Dialogic must be obtained. Once the support contract is obtained, a username and password will be supplied via email.
Dialogic IMG 1004 Integrated Media Gateway Quick Start Guide Configuring Linux on GCEMS server IMPORTANT: Please read and understand the IMG 1004 technical documentation prior to performing any setup or installation procedures. The documentation can be accessed through the following site: http://www.dialogic.com/manuals If the IMG 1004 was purchased with the GCEMS Server then the Linux Red Hat Operating System and GCEMS application have already been installed.
Index Connecting and Configuring Network Management Port ‘CTRL’ The information below will provide the user with a basic setup sequence for connecting and configuring the IMG 1004 along with the GCEMS server to download system software and start configuring the IMG 1004 using the ClientView GUI. On the rear of the IMG 1004 are the network interfaces. The first interface -CTRL - is a Fast Ethernet port dedicated to network management.
Dialogic IMG 1004 Integrated Media Gateway Quick Start Guide Installing GCEMS Software. To take advantage of all new features, it is recommended that the latest version of GCEMS software be installed on the GCEMS Server. The most current software can be obtained from the Dialogic Technical Support website. 1. Go to the Dialogic Support Technical Website at http://www.dialogic.com/support 2. Select „Downloads‟. You will require a logon username and password to access the downloads site.
Index Connecting DATA Port 1. The port DATA that is located on the rear of the IMG 1004 is a 100 Mbit port and is dedicated to VoIP Bearer traffic. The DATA port can be either on the same IP network as the management network, or can be connected to a separate network. See the topics under the following headings in the Online Documentation for more information.
Dialogic IMG 1004 Integrated Media Gateway Quick Start Guide Connecting TDM Signaling and Bearer Ports The Bearer ports (Interface Offsets) 0-4 are connected to the TDM network. Each Bearer Port can have signaling and bearer channels configured on it. ISDN D-channels and B-Channels are brought in over the Bearer Ports CAS signaling and voice channels are brought in over the Bearer Ports SS7 Links are brought in over Bearer Ports.
