User guide

Dialogic
®
DSI Development Package for Linux - Release Notes Release 6.5.3
9
Release 6.5.3
1 Overview
This is a full release of the Development Package for Linux containing
protocol updates to MAP, SCCP and M3UA.
This release updates the MAP-SEND-IDENTIFICATION service adding
CurrentSecurityContext data, adds support for EPS-AuthenticationSetList data
as used by the MAP V3 service SendAuthenticationInfo and updates the MAP-
UPDATE-GPRS-LOCATION, MAP-CANCEL-LOCATION and MAP-PURGE-MS
services so that they are in accordance with MAP Release 8.
M3UA operation is enhanced to optionally allow auditing of congested
destinations to be disabled.
An important M3UA correction is included to address an issue introduced in
Release 6.5.1 which potentially prevents M3UA routes becoming available.
The release includes further changes and corrections as detailed below.
This is the first full release since Release 6.5.1 and it is fully backwards
compatible with that release.
1.1 Applicability
This release is applicable to all users. In particular any M3UA users using
Release 6.5.1 or later should upgrade to this release as it corrects a potential
issue with M3UA route availability.
The following User Documentation updates are applicable to this release of
the Development Package:
Dialogic
®
DSI Protocol Stack – MAP Programmer’s Manual, Issue 19.
1.2 Resolved Customer Issues
The following customer issues are resolved in this release: IPY00102115,
IPY00102297 and IPY00102308.
2 New Functionality
2.1 MAP – EPS-AuthenticationSetList data
Support for EPS-AuthenticationSetList data as used by the
SendAuthenticationInfo service has been added to the response in accordance
with the MAP specification 3GPP TS 29 002 version 9.4.0 (Release 9). Two
additional parameters have been added to the request for the same service:
numberOfRequestedAdditional-Vectors and additionalVectorsAreForEPS. The
parameters for both changes are only required for MAP-V3 Application
Contexts as defined in the specification.