User guide

Dialogic
®
DSI Development Package for Linux - Release Notes Release Notes for V5.09
72
2.12 s7_mgt - Non-consecutive links
In earlier releases of the Development Package, if the config.txt file contained
MTP_LINK commands with non-consecutive link reference numbers, the
configuration commands generated by the s7_mgt utility would be rejected
by the MTP3 module. In this release the commands are not rejected
2.13 Drivers report source code version
The drivers included in this release of the Development Package have been
extended to additionally report the Source code version in the message sent
to the kernel ring buffer eg.
Dialogic SS7HD Device Driver V100.00 (Source V1.20)
2.14 Notify message for void config.txt message
If configured, the s7_mgt utility now generates a Notify message even if the
config.txt file does not contain any configuration commands.
3 Other Changes
3.1 Updated License Terms
The license terms for the board drivers which are included in this
Development Package have been updated to more closely follow the common
practice for Linux Drivers. Details are given in the license agreement which
accompanies this Development Package and the full license agreements are
included in each impacted subdirectory.
The set of pre-compiled drivers is no longer delivered with the Development
Package.
3.2 Correction to Device Driver Installation
Previous releases of the Development Package contained a problem in the
device driver installation scripts which could prevent more than two signaling
boards from being correctly configured. This problem affected the SPCI,
SS7HD and SS7AM1 signaling boards and has now been resolved.
3.3 Install problems for SS7AM driver
The SS7AM driver was failing to compile correctly on some versions of the gcc
compiler. This would result in a Kernel panic when the user attempted to load
the driver. This problem has been resolved in this release of the Development
Package.
3.4 Comments in MMI commands
In earlier releases MMI style commands containing comments were rejected
by the s7_mgt utility. In this release these commands are processed
normally.