User guide

Dialogic
®
DSI Development Package for Linux - Release Notes Release 6.6.1
7
SNSLI:SNLINK=n, … M2PA_OPTIONS=0x0010;
3.14 M2PA – Timer Value Ranges
The range of timer values supported by M2PA has been increased to allow
operation in networks such as DoCoMo in Japan. The following table shows
the permitted range and default values:
M2PA Timer
Maximum
Minimum
Default
Units/Granularity
T1
50s
10s
40s
Seconds
T2
50
5
10
Seconds
T3
15
1
2
Seconds
T4N
10
2
7
Seconds
T4E
1000ms
400ms
500ms
100ms
T6
6
1
3
Seconds
T7
3000ms
500ms
1000ms
100ms
3.15 DMR - P_ABORT on timer expiry (IPY00115281)
When using the Authentication Server State Machine (typical of LTE Servers)
and the User guard timer expires then a P_ABORT indication is generated by
DMR for the User Application. This indication was erroneously being sent to
module id 0x00. This has now been resolved and the indication is being
correctly sent to the User Module Id
3.16 DMRAPI – Support 64 bit AVP types
This release adds support for unsigned and signed 64 bit AVP types to the
Diameter API library. Classes diameter::Unsigned64Avp and
diameter::Integer64Avp types have been added to DmrApi.lib
3.17 DMRAPI – Result Codes
A new enumeration containing result codes defined in RFC3588 has been
added with ResultCodeAVP.
3.18 s7_mgt – Support for 256 RAS (IPY00102763)
This release increases the maximum number of Remote Application Servers
(RAS) that s7_mgt can configure from 64 to 256 to allow the full capacity of
M3UA to be used.
3.19 s7_mgt – Multiple RAS with same DPC
This release allows M3UA to be configured with multiple associations
connecting to the same remote Destination Point Code (DPC). This is
achieved by adding a Local Application Server (LAS) parameter to the SNRAI
command to ensure that each Remote Application server (RAS) has a unique
combination of DPC and LAS. The full syntax of the SNRAI command is as
follows: