User guide

Dialogic
®
DSI Development Package for Linux - Release Notes Release Notes for V5.11
67
3 Other Changes
3.1 SSDH Hot Swap Support
In earlier releases of the Development Package, Hot swap settings were not
supported. This support has now been added and a single board maybe hot
swapped at a time.
3.2 SPCI Support for 64bit Kernels
The SPCI Linux Device Driver has been updated to support 64bit kernels. The
SPCI Device Driver’s build and installation instructions are described in the
Dialogic
®
DSI SPCI Network Interface Boards Programmer's Manual.
3.3 ANSI SUA support
s7_mgt now allows SUA to optionally be configured to support ANSI mode of
operation.
3.4 Support for mixed M3UA Link Types
In previous releases support for Remote Application Server (RAS) and
Signaling Gateway (SG) links was only possible if unique Identifiers were
used for the RAS and SG parameters. This has been resolved.
3.5 Parameter format restrictions in MMI commands
In earlier releases, the s7_mgt module could give unexpected results if
spaces were used in numeric parameters (e.g. 0x7fff ffff). Configuration
commands with spaces in the middle of strings are now rejected.
3.6 MBM Reliability Improved
In earlier releases the MBM module could occasionally, in certain
configurations, fail to initialise correctly. This problem has been resolved.
3.7 PCAP Support for MTP3 running on-board
The PCAP logging functionality provided by the s7_log module has been
extended to support configurations where the MTP3 module is running on the
board.
3.8 Monitoring 56/48kb/s links on SS7HD Boards
A correction has been made within the s7_mgt module to ensure that
monitoring of 56kb/s and 48kb/s links is correctly set up on SS7HD boards.
3.9 Restriction on IPSP Links removed
In the previous release of the s7_mgt module only 4 M3UA links could be
configured. This restriction has now been removed and it is possible to
configure up to 64 links.