User guide

Dialogic

DSI Development Package for Linux - Release Notes Release 6.6.1

prior to any SCCP_GTT_PATTERN, SCCP_GTT_ADDRESS or SCCP_GTT

commands in the configuration file.

2.7 SCCP – Global Title Load Share Table Statistics

The message SCP_MSG_R_GLST_STATS (0x6756) has been added to allow

user to obtain usage statistics for configured Global Title Load Share tables.

2.8 SCCP – Event Report Limiting

To avoid excessive reporting of identical Maintenance Events

(SCP_MSG_MAINT_IND) and Software Events (SCP_MSG_ERROR_IND) that

can reduce system throughput, SCCP now issues a maximum of 10 event

indications for an event type over any one minute interval. Further events

during the interval are suppressed.

2.9 M3UA – Support for 384 Associations

This release increases the maximum number of SCTP Associations from 256

to 384. Users with licenses that support 384 or more link equivalents can

now use up to a maximum of 384 associations. SCTPN, SCTP and s7_mgt

also support this increase in capacity.

2.10 M3UA – New 8 link License

This release adds support for a new 8 link equivalent license.

2.11 MST – Monitoring Diameter Messages

The capability of the SIGTRAN monitoring tool (MST) has been enhanced to

support monitoring of SCTP based Diameter traffic. To invoke this capability

the user should set bit 8 in the ‘stn_mask’ when configuring the MST Tap.

2.12 DMR – Diameter Dynamic Resource Removal

This release includes updates to the DMR management interface to support

the dynamic removal of configured resources. The following new messages

provide this capability and full definitions can be found in the DMR

Programmer’s Manual:

DMR_MSG_APP_REM – Diameter Application Removal

DMR_MSG_PEER_REM – Diameter Peer Removal

DMR_MSG_ROUTE_REM – Diameter Route Removal

DMR_MSG_ROUTE_LIST_REM – Diameter Route List Removal

DMR_MSG_NC_REM – Diameter NC Removal

2.13 DTS/DTC Operation

Operation of DTC/DTS (for use with the Dialogic

DSI SS7G41 Signaling

Server in SIU mode) has been enhanced to reduce the need for application

intervention to recover from transient failures of the IP network. Operation of

s7_mgt has been enhanced to support additions to the DTC_CONFIG

command and a new DTS_SERVER command. The functionality is detailed in

DTS User Guide.