User guide

Dialogic
®
DSI Development Package for Linux - Release Notes Release 6.4.0
31
3.25 s7_play – Waiting forever
This release prevents s7_play waiting forever for a response to a message
that it failed to send. In the event that during execution of the “W” command
GCT_send() fails, s7_play now reports an error and terminates.
3.26 s7_log – Additional decode (IPY00099532)
s7_log now fully decodes the MGT_MSG_LIC_EVENT message.
When decoding the M3U_MSG_NOTIFY_IND message, s7_log now only
displays the ASP identifier when present in the message. Previously “ASP=0”
was displayed when the ASP identifier was not present.
s7_log will now log messages traced from the MTP3 to MTP2 interface on the
SPCI board to the PCAP log file. These messages are of type
SS7_MSG_TX_REQ and were not previously mapped to PCAP format.
3.27 dsistat - M3UA, TCAP & LIU Status
The dsistat management tool has been enhanced to report TCAP resource and
TCAP dialog status. Handling of the id value for when requesting the status of
a M3UA Remote Server has been corrected and additional LIU measurements
for bit errors and code violations are displayed.
3.28 dsitrace - M3UA and AAL5 Tracing
The dsitrace management tool has been enhanced so that it can be used to
activate ATM AAL5 tracing. The default trace mask for M3UA used by dsitrace
has been modified to request tracing API_MSG_TX_REQ and
API_MSG_RX_IND messages. Previously the input and output mask were by
default set to 0 requiring a user to always specify which messages should be
traced.
Dialogic
22-Mar-12
Revised 13-Apr-12