User guide

ManualsBrandsDialogic ManualsNetwork CardDSI SS7MD

Dialogic

DSI Development Package for Linux - Release Notes Release 6.4.0

Release 6.4.0

1 Introduction

This is a feature release which adds support for Red Hat Enterprise Linux 6

and provides increased capacity support for the SS7MD board (up to 8 boards

in a server) and the SS7LD board (up to 8 links in a system over multiple

boards).

The release also includes protocol updates to SCCP, MAP, M2PA and MST and

enhanced status reporting through gctload. Further changes and corrections

are includes as detailed below.

This is the first full release of the Dialogic

DSI Development Package for

Linux since 6.3.8 and it is fully backwards compatible with that release.

NOTE: Dialogic recommends that the complete Development Package

is used when upgrading from a previous release. If this is not

possible users should note that licensed protocol binaries from the

6.4.0 (and later) releases will not work with versions of the gctlib

shared object library prior to the 6.4.0 release. If a user needs to use

a 6.4.0 (or later) licensed binary in conjunction with an earlier

release of the Development Package then it is essential to also install

and use the gctlib shared library from the 6.4.0 (or later)

Development Package.

1.1 Applicability

This release is applicable to all users.

If a user needs to use a 6.4.0 (or later) licensed binary in conjunction with an

earlier release of the Development Package then it is essential to also install

and use the gctlib shared library from the 6.4.0 (or later) Development

Package.

The following User Documentation updates are applicable to this release of

the Development Package:

Dialogic

DSI – Software Environment Programmer’s Manual, Issue 10

Dialogic

DSI Protocol Stacks – SCCP Programmer’s Manual, Issue 9,

Dialogic

DSI Protocol Stacks – TCAP Programmer’s Manual, Issue 12,

Dialogic

DSI Protocol Stacks – MAP Programmer’s Manual, Issue 16,

Dialogic

DSI Network Interface Boards– SPCI Programmer’s Manual, Iss 7,

Dialogic

DSI Protocol Stacks – DTS User Guide, Issue 9.

This release includes an updated ss7.dc4 code file (V5.12) for use with the

Dialogic

SS7HD Network Interface Board and the ss7.dc7 (V1.08) code file

for use with the Dialogic

SS7LD Network Interface Board. The release notes

for the code files are available separately.

This release includes an updated SNMP M3028_6_2 MIB package (V2.02)

which includes support for the Dialogic® DSI SS7G41 Signaling Server.