Specifications

4 Message Reference
78
15
2
cong_onset
17
2
cong_abate
19
2
cong_discard
21
2
MaxCC
23
2
MaxPD
25
2
n1
27
2
co1
29
2
co2
31
2
co3
33
2
ca1
35
2
ca2
37
2
ca3
39
2
cd1
41
2
cd2
43
2
cd3
45
1
trace_id
Description
This message is used to configure the operational parameters for an individual Q.SAAL
link and to cause the power up action defined in Q.2140/Q.2110 to be executed. One
such message must be issued to Q.SAAL for each link to be used. The
QSAAL_MSG_TIMERS message can be used to modify timer values.
The vpi/vci combination configured here must not match the default specified for the
cell stream.
Once the message has been received and processed by the Q.SAAL module,
API_MSG_RX_IND messages will immediately get sent to the module ID indicated
(with the ID field set to the upper_link_id).
Messages of length greater than the maximum configured for the underlying cell
stream will be silently discarded. A count of discards may be retrieved via an ATM
stats request ATM_MSG_R_STREAM_STATS.
link_id
Identifier for this link.
Note: This identifier is required to be unique only within the context of the board.
Options
Bit
Options
1
Set to 1 to enable multiple congestion states and multiple message priority option. This
option should always be enabled when running in ANSI mode.
Others
Reserved for future use and must be set to 0.
upper_link_id
Upper layer link identifier
cell_stream
The identity of the cell stream over which this link will run.