Specifications

Dialogic
®
DSI SS7MD Network Interface Boards Programmer's Manual Issue 4
35
config_type
Set to 3 when using a DSI SS7MD Board. A separate link layer configuration message
should be sent for each link using the MGT_MSG_L1_CONFIG message.
flags
Global flags with the following bit significance:
— Bit 15 is set to 1 for diagnostics purposes to cause the results of board configuration
to be passed to the host. When set, all confirmation messages generated internally on
the board during the configuration sequence are sent to the 0xdf module ID on the
host.
— All other bits are reserved for future use and should be set to 0.
l1_flags
Level 1 flags with the following bit significance:
— Bit 0 controls the layer 1 clock reference source. If set to 0, the clock is recovered
from the onboard oscillator. If set to 1, the clock is recovered from one of the line
interfaces. Line interfaces can be individually configured with the LIU_MSG_CONFIG
message to explicitly be excluded from recovering the clock from the interface.
— All other bits are reserved and should be set to 0.