Network Card User Manual
Table Of Contents
- Dialogic® DSI SS7MD Network Interface Board Programmer's Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Specification
- Chapter 3: Installation
- Chapter 4: Dialogic® DSI SS7MD Board Configuration and Operation
- 4.1 Regulatory and Geographic Considerations
- 4.2 System Structure
- 4.3 Running Host Binaries With Dialogic® DSI SS7MD Board
- 4.4 System Configuration
- 4.5 Protocol Configuration
- 4.6 Monitoring
- 4.7 ATM Monitoring
- 4.8 Switching Timeslots between LIUs
- 4.9 Received Message Timestamping
- 4.10 High Speed Link Operation
- 4.11 Operation of the Thermal Sensor
- Chapter 5: Program Execution
- Chapter 6: Message Reference
- Chapter 7: Configuration Command Reference
- 7.1 Physical Interface Configuration Commands
- 7.2 Monitor Configuration Commands
- 7.3 MTP Configuration Commands
- 7.4 ATM Configuration Commands
- 7.5 ISUP Configuration Commands
- 7.6 TUP Configuration Commands
- 7.7 SCCP Configuration Commands
- 7.8 DTC Configuration Commands
- 7.9 TCAP Configuration Commands
- 7.10 MAP Configuration Commands
- 7.11 INAP Configuration Commands
- 7.12 IS41 Configuration Commands
- Chapter 8: Host Utilities
- Appendix A: Protocol Configuration Using Discrete Messages
- Appendix B: Thermal guidelines for selecting suitable servers for use with a Dialogic® DSI SS7MDL4 Network Interface Board
- Glossary
- Index
25
Dialogic
®
DSI SS7MD Programmer’s Manual Issue 3
Chapter 4: Dialogic® DSI SS7MD Board Configuration and Operation
Before attempting software configuration, you should gain an appreciation of the flexibility of the protocol
stack, the run-time options that exist and the mechanisms that are used to select specific features. This
section gives an overview of these options. You should also read the Software Environment Programmer’s
Manual that describes the basic principles of modules and message passing.
This chapter provides information about:
• Regulatory and Geographic Considerations
• System Structure
• Running Host Binaries With Dialogic
®
DSI SS7MD Board
• System Configuration
• Protocol Configuration
• Monitoring
• ATM Monitoring
• Switching Timeslots between LIUs
• Static Initialization
• Received Message Timestamping
• High Speed Link Operation