Network Card User Manual
Table Of Contents
- Dialogic® DSI SS7MD Network Interface Board Programmer's Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Specification
- Chapter 3: Installation
- Chapter 4: Dialogic® DSI SS7MD Board Configuration and Operation
- 4.1 Regulatory and Geographic Considerations
- 4.2 System Structure
- 4.3 Running Host Binaries With Dialogic® DSI SS7MD Board
- 4.4 System Configuration
- 4.5 Protocol Configuration
- 4.6 Monitoring
- 4.7 ATM Monitoring
- 4.8 Switching Timeslots between LIUs
- 4.9 Received Message Timestamping
- 4.10 High Speed Link Operation
- 4.11 Operation of the Thermal Sensor
- Chapter 5: Program Execution
- Chapter 6: Message Reference
- Chapter 7: Configuration Command Reference
- 7.1 Physical Interface Configuration Commands
- 7.2 Monitor Configuration Commands
- 7.3 MTP Configuration Commands
- 7.4 ATM Configuration Commands
- 7.5 ISUP Configuration Commands
- 7.6 TUP Configuration Commands
- 7.7 SCCP Configuration Commands
- 7.8 DTC Configuration Commands
- 7.9 TCAP Configuration Commands
- 7.10 MAP Configuration Commands
- 7.11 INAP Configuration Commands
- 7.12 IS41 Configuration Commands
- Chapter 8: Host Utilities
- Appendix A: Protocol Configuration Using Discrete Messages
- Appendix B: Thermal guidelines for selecting suitable servers for use with a Dialogic® DSI SS7MDL4 Network Interface Board
- Glossary
- Index
179
Dialogic
®
DSI SS7MD Programmer’s Manual Issue 3
Figure 3. Protocol Configuration Message Sequence Diagram
(0x3f17)
SSD_MSG_RESET (0x7680)
(0x3680)
SSD_MSG_RST_BOARD (0x7681)
(0x3681)
Board Status Indication (0x06a0)
MGT_MSG_CONFIG0 (0x7f10)
(0x3f10)
(0x3e34)
Repeated per LIU
Repeated per Link
MGT_MSG_L1_CONFIG (0x7f17)
LIU_CONFIG0 (0x7e34)
SS7_MSG_CONFIG (0x7203)
(0x3203)
(0x3300)
MTP_MSG_CONFIG (0x7303)
(0x3303)
MTP_MSG_CNF_LINK (0x7311)
(0x3311)
MTP_MSG_CNF_LINKSET (0x7310)
(0x3310)
MTP_MSG_CNF_ROUTE (0x7312)
(0x3312)
MTP_MSG_SL_ACT (0xc30a)
(0x830a)
Repeated per Linkset
Repeated per Route
USER_MGT SSD
On-Board
MGT
MTP3
MTP2
MTP2 CTSWX
MTP_MSG_RESET (0x7300)
SSD_MSG_STATE_IND (0x06a0)
SSD_MSG_BOARD_INFO (0x7689)
(0x3689)
Repeated per board
Geographic
addressing
only