Specifications

4 Message Reference

— Bit 9 - in general configurations, this should be set to 0. In dual fault

tolerant configurations, Board A must set bit 9 to 0 while Board B must

set bit 9 to 1. For further information, refer to the Dialogic

DSI

Signaling Servers Manual - 05-2302-xxx - Appendix A.

— Bit 13 causes the board to drive the CT_NETREF1 clocks on the CT Bus

when set to 1. The highest priority in-sync line interface is used as a

clock source. If this bit is set to 0, the CT_NETREF1 clock is not driven.

By default, liu_id = 0 is the highest priority and liu_id = one less than

the number of LIUs, is the lowest. The priority can however be modified

using the MVD_MSG_CLOCK_PRI message.

— All other bits are reserved and should be set to 0.