Specifications

Dialogic
®
DSI SS7HD Network Interface Boards Programmer's Manual Issue 11
59
— 1: PCI address mode
— 2: H.110 address mode
— 3: ADDR switch address mode
— 4: PICMG 2.0 address mode.
Refer to the Software Environment Programmer’s Manual for information about ssdh
parameters.
btype
The board type. For SS7HD boards, this parameter is set to 3.
addrsw
The board address value. This value depends on the geographic address mode in which
the ssdh module is running (see ssd_mode above):
— If ssdmode is set to 1, this value is the logical ID assigned by the driver.
Typically, the first board in the system is assigned address 0.
— If ssdmode is set to 2, this value represents the H.110 address of the
board.
— If ssdmode is set to 3, this value represents a number as defined by the
rotary switch on the board.
— If ssdmode is set to 4, this value represents the physical chassis shelf
position (applicable to CompactPCI boards only).
numsp
The number of signaling processors on the board.
subsysid
The PCI subsystem ID. Currently, the values used are 0x5005 for SS7HDP PCI boards,
0x5006 for SS7HDC CompactPCI boards and 0x500a for SS7HDE PCI Express boards.
sernum
The serial number of the board.