Specifications

Dialogic
®
DSI SS7HD Network Interface Boards Programmer's Manual Issue 11
31
2.6 SNMP Support
The Dialogic
®
Distributed Structured Management Information (DSMI) Simple Network
Management Protocol (SNMP) Agent provides SNMP monitoring functionality for the
Dialogic
®
DSI SS7 Development Package.
Dialogic
®
DSMI SNMP software supports SNMP V1, V2, and V3 reporting the state and
events for Dialogic
®
DSI SS7HD Network Interface Boards and Dialogic
®
DSI Protocol
Stacks through use of SNMP traps as well as queries from an SNMP manager.
The Dialogic
®
DSMI MIBs are distributed within the Dialogic
®
DSI SS7 Development
Package in the /opt/DSI sub-directory as a compressed ZIP file: dsi-mibs.zip.
For details of the DSMI SNMP MIBs supported, events, SNMP traps and configuration,
refer to the Dialogic
®
DSI Protocol Stacks SNMP User Manual.
2.7 Regulatory and Geographic Considerations
Certain functions of the Dialogic
®
DSI SS7HD Network Interface Board, although
implemented in hardware, have selectable options that are configured by the software.
A user or integrator must consider the requirements of the application when choosing
these settings, but must also consider any local regulatory requirements for the
intended deployment location to provide a compliant overall system. As an aid to this
process, the table below details some of the areas where the correct selection of
configuration options may be required.
Configuration Area
Configuration Options
T1/E1/J1
Ports
Interface type
liu_type parameter in LIU_CONFIG command
Pulse shape
liu_type parameter in LIU_CONFIG command
Line code
line_code parameter in LIU_CONFIG command
Frame format
frame_format parameter in LIU_CONFIG command
CRC/E-bit operation
CRC_mode parameter in LIU_CONFIG command
Clock priorities
flags parameter in SS7_BOARD command and
options parameter in LIU_CONFIG command
CT Bus
Master/Slave configuration
flags parameter in SS7_BOARD command
Bus termination
flags parameter in SS7_BOARD command
Links
Link termination or monitoring
mode
MTP_LINK or MONITOR_LINK commands
Note: For details on these configuration commands please refer to Dialogic
®
Distributed Signaling
Interface Components - Software Environment Programmer's Manual