Specifications

Dialogic
®
DSI SS7HD Network Interface Boards Programmer's Manual Issue 11
27
2.5 License Buttons
The DSI SS7HD code file supports different protocol module combinations that are
enabled by fitting the correct License button on the board. Each license button is
engraved with a two-letter code that is used for identification. The following table
shows Item Market Names (IMNs) for the currently available license buttons and the
two-letter code corresponding to each IMN.
Table 5. Dialogic
®
DSI SS7HD License Buttons
License Button IMN
Code
SS7SBHDFBA
BA
SS7SBHDFBC
BC
SS7SBHDFBD
BD
SS7SBHDFBE
BE
SS7SBHDFBF
BF
Note: A license button is not required for the SS7HDCN16W board, since this board operates in
DTI run mode only. See Section 2.5.1, “Run Modes” for more information.
2.5.1 Run Modes
The run_mode parameter in either the SS7_BOARD command or the Board Reset
Request message determines the protocol modules that are started by the code file at
run time. The following table shows the relationship between the license button code,
the run mode and the protocol modules that are enabled (see Table 2 on page 26).
Note: The SS7HDCN16W is suitable for DTI run mode only, therefore a license button is not
required.