Specifications

Dialogic
®
DSI SPCI Network Interface Boards Programmer's Manual Issue 7
37
rai_gen
Description
0
Do not change RAI / Yellow alarm generation mode.
1
Disabled - do not generate RAI / Yellow alarm.
2
Forced active - generate RAI / Yellow alarm.
3
Automatic generation of RAI / Yellow alarm upon loss of
synchronization.
loop_mode
The diagnostic loop back mode taken from the following table:
loop_mode
Description
0
Do not change diagnostic loop back mode.
1
Disabled - remove any diagnostic loop.
2
Payload loopback.
3
Remote loopback.
4
Local loopback.
Status Response
The confirmation message (if requested) indicates success by status of zero.
On error, the following status values can be found in the confirmation message.
Value
Mnemonic
Description
0x01
None
Invalid framer ID.
0x02
None
Invalid message length.
0x03
None
Control parameters are not consistent with the type of device being
controlled or with each other.