User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide — September 2007 99
Dialogic Corporation
Parameter Reference
Allowed Values:
• None = No calling party is sent.
• VoIP = Calling party is derived from the VoIP call/mwi-request.
• Static = A statically configured calling party is used.
• VoIP_Preferred = Calling party is derived from the VoIP call/mwi-request. If not available
from VoIP, then the statically configured calling party is used.
Default Value = Static
INI File Parameter Name = gwTdmOutboundCallingPartySrc
3.7.4.8 Static TDM Calling Party
Description: Specifies the calling party that will be provided to the TDM interface if Outbound
TDM Calling Party Source is set to Static or VoIP_Preferred.
Note: When a DMG2000 is connected to a Mitel PBX and is configured for E1 QSIG, this parameter
must be set to one of the following options in conjunction with the Outbound TDM Calling Party
Source parameter:
• Outbound TDM Calling Party Source set to Static and Static TDM Calling Party set to a
number (e.g. 1234).
• Outbound TDM Calling Party Source set to Vo IP and the VoIP endpoint must provide a
calling party number in the VoIP call/MWI call request.
• Outbound TDM Calling Party Source set to VoIP_Preferred and Static TDM Calling Party set
to a number (e.g. 1234).
Allowed Values: Any valid dialable number
Default Value = 1234
INI File Parameter Name = gwTdmOutboundCallingParty
3.7.5 CPID Parsing Configuration
Description: Modifying this data affects either the in-band Type I (on-hook) or Type II (off-hook)
CPID parsing of the DMG2000, depending on how the unit is configured. The text box on this page
can be easily modified by either pasting parsing rules into it from a text file or directly modifying
the contents of the control. See Chapter 6, “Media Gateway Parsers” for further information about
the creation and use of parsing rules.
3.8 H.323 Parameters
The H.323 parameters include:
• Gatekeeper Mode
• Gateway Name