User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide — September 2007 87
Dialogic Corporation
Parameter Reference
3.7 T1/E1 Parameters (DMG2000 Only)
The T1/E1 parameters are used to configure the T1 and E1 port(s) on a DMG2000 and include the
following groups:
• T1/E1 Mode Group
• T1 CAS Protocol Group (T1 CAS Signaling Mode)
• T1 ISDN Protocol Group (ISDN Signaling Mode)
• E1 ISDN Protocol Group (ISDN Signaling Mode)
• CPID Parsing Configuration
3.7.1 T1/E1 Mode Group
The parameters in the T1/E1 Mode group include the following:
• Line Mode
• Signaling Mode
• Interface Side
3.7.1.1 Line Mode
Description: Specifies the Line Mode type (T1 or E1) to which the T1/E1 connector will be
interfacing.
Allowed Values:
• T1 = Interfaces to T1 line (23/24 channels)
• E1 = Interfaces to E1 line (30 channels)
Default Value = T1
INI File Parameter Name = t1e1LineMode
3.7.1.2 Signaling Mode
Description: Specifies the signaling mode to be used.
Allowed Values:
• CAS = Channel associated signaling
• ISDN = Common channel signaling
Default Value = CAS
INI File Parameter Name = t1e1Signaling
Note: Unit requires a restart if this parameter value is changed.