User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide — September 2007 37
Dialogic Corporation
Configuring the Media Gateway
• For DMG1000 models, select PBX Type (See PBX Type parameter information in
Section 3.3, “System Parameters”, on page 51.)
• For DMG2000 models, select:
– Line Mode (Section 3.7.1.1, “Line Mode”, on page 87)
– CAS Protocol (Section 3.7.1.2, “Signaling Mode”, on page 87 and Section 3.7.2.1,
“T1 CAS Protocol”, on page 88) or ISDN Protocol (Section 3.7.1.2, “Signaling
Mode”, on page 87 and Section 3.7.3.1, “ISDN Protocol”, on page 94)
8. When prompted that the parameters have been successfully configured, type restart at the
PIMG> prompt to restart the Media Gateway.
You should now be able to connect to the Media Gateway from the Web Interface using the
newly configured IP Address.
2.3 Changing the Password
The steps for changing the password are described in the following procedure:
1. Start your Web browser.
2. In the Web browser address box, enter the IP address of the Media Gateway that you wish to
access.
3. When the System Login Web page appears, enter the user name and current password in the
boxes provided and click on the Log On button.
Note: The user name and password are case sensitive.
4. Once the login has been accepted, the Media Gateway Status/Configure Web page will appear.
Select the Password Web page from the Configure menu on the left side of the page.
5. Enter the current password in the Old Password box.
6. Enter the new password in the New Password box.
7. Enter the new password a second time in the Confirm box. Then, click on the Change button
to replace the old password with the new password.
2.4 Configuration Procedure
The Media Gateway is configured using a Web interface.
To change configuration parameter values through the Web interface, use the following procedure:
1. From a workstation connected to the Media Gateway via the Ethernet, start the Web browser.
2. Enter the IP address assigned to the Media Gateway. For example:
http://10.12.13.74
3. When the System Login Web page appears, enter admin in the User Name box and your
password in the Password box, then click on the Log On button.
Note: The user name and password are case sensitive.