User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide — September 2007 227
Dialogic Corporation
Diagnostics
Note: H.323 is only supported in Version 5.1 SU1 Software or earlier.
9.6.2.2 Trace Type
Trace type defines the level of tracing. For example, to capture only errors for the VoIp trace key,
the trace type would be set to:
trace voip error on
The following table describes the trace types that are supported:
Web Web Server ●●●
Log Diagnostics Logging Module (aka
Enhanced Diagnostics)
●●●
Phd Phone-Driving GCC Layer (3) ●●●●●
PhnDrv Phone-Driving State Machine (3) ●●●●●
iNimDrv NIM (telephony network) Driver (3,4) ●(11) ●●●●●
Dcif Direct-Connect Interface (5) ●●●●●
NimCtlDc NIM/DirectConnect Interface (5) ●●●●●
PBXTest PBX Self Test Application (12) ●●●● ●
LTA LearnTone Application (12) ●●●● ●
NOTES:
1) Currently SIP only - enable to trace SIP packets
2) Serial Interface API only active if serial mode enabled
3) Active only if in phone-driving mode
4) Active only on AMI DMG1000
5) Active only in Direct-Connect mode
6) enable to see telephony hookswitch, lamps, voice state, CPID, displays, tone detection (call progress and dtmf)
7) enable to trace RTP packet and error statistics during a media session
8) enable to trace telephony protocol packets (encoded in release version)
9) enable to trace serial telephony interface packets (serial server only)
10) enable to trace H.323 and SIP Trillium code
11) enable to trace iNim/DMG1000 interface protocol
12) Active only if feature is run
13) DMG1000 only
14) DMG2000 only
15) RAW ISDN layer 3 messages
Table 11. Supported Trace Keys (Continued)
Trace
Keys
Description Prot Code Error Warn Init Alarm Event Stat