User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide — September 2007 209
Dialogic Corporation
Diagnostics
Figure 51. Call Flow for Send Message Waiting Status
9.3.2.3 Test Status
When a diagnostic test is executed the test results are shown in the PBX Self Verification Test
Status table on the Web page.
The test can be canceled at any time by pressing the Cancel Test button.
When the test is completed a hyperlink will be displayed to allow the user to return to the PBX Self
Verification Test configuration Web page.
Test Result Symbol Description
- Test skipped because not configured or not available (no capability,
not enabled, or not in-service).
n Test was pending but did not execute because a failure occurred.
P Test Passed
F Test Failed