Technical data

Dialogic® Diva® SIPcontrol™ Software Configuration
Dialogic
®
Diva
®
SIPcontrol
TM
Software 1.8 Reference Guide page 36
Conditions
You may configure certain conditions for a route. If you do not configure any conditions, the route is used as
default route.
Note: If prefixes need to match, the digits of the prefix need to be prepended by a caret symbol ("^"); otherwise,
these digits would match within the number as well, e.g. 0 would also match [e-mail].
You may configure the parameters shown in the graphic and explained below:
Note: A route can only be matched if the three condition parts (called number, calling number, and redirect
number) match their call address counterpart in any of the lines. Empty condition entries always match, i.e., a
line with the three condition parts left empty will always apply, thus working as a default route.
Address Manipulation
You may configure the parameter shown in the graphic and explained below:
Called number: If the routing is supposed to be valid only for specific calls, enter the called party number to which
the route should apply. The Dialogic
®
Diva
®
SIPcontrol
TM
Software compares the current called
party number against the called number entered here. If they do not match, the Diva SIPcontrol
software verifies the next routing until it finds a match.
Calling number: If the routing is supposed to be valid only for specific calls, enter the calling party number to which
the route should apply. The Diva SIPcontrol software compares the current calling party number
against the calling number entered here. If they do not match, the Diva SIPcontrol software verifies
the next routing until it finds a match.
Redirect number: If the routing is supposed to be valid only for specific calls, enter the redirecting number to which
the route should apply. The Diva SIPcontrol software compares the current redirecting number
against the redirect number entered here. If they do not match, the Diva SIPcontrol software
verifies the next routing until it finds a match.
Address Map: If a route matches, the address manipulation setting allows for modifying the call addresses
according to your needs. For example, if calls with the called party number starting with "9" should
be directed to a specific peer, it might be desirable to remove this digit. This can be done with a
special address map configured. Note that you need to configure the address map as described
under Address Map Configuration
on page 39 before you may select it here.