Technical data

Dialogic® Diva® SIPcontrol™ Software Configuration

Dialogic

Diva

SIPcontrol

Software 1.8 Reference Guide page 30

SIP Peer Configuration

A SIP peer is a specific endpoint to and from which the Dialogic

Diva

SIPcontrol

software will establish calls.

The peer-specific settings may be used to adapt the Diva SIPcontrol software's behavior towards this peer.

To add a SIP peer, click the Add button. To change the settings for the enabled SIP peer, click the Details button

on the right hand side. To open the online help for a specific parameter, click the parameter and a window with

the help text will pop up. The following menus are available for configuration:

• Edit SIP Peer Configuration

below

• Enhanced Configuration

on page 31

• S

ession Timer on page 32

• Address normalization on page 33

• Authentication Configuration

on page 34

Edit SIP Peer Configuration

You may configure the parameters shown in the graphic and explained below:

Name: Enter a name for the SIP peer. A SIP peer is a specific endpoint to and from which the Diva

SIPcontrol software establishes the calls.

Peer type: Some SIP peers need a specific peer, such as a Microsoft

Exchange Server, to work properly with

the Diva SIPcontrol software. If this is the case for your configuration, select the specific SIP peer.

If not, select Default.

Host: Enter the host name or IP address of the peer. The name must be resolvable by local name

resolution. During the establishment of a call, the host name is sent by this peer exactly as entered

here, unless an address map applies that converts the host name in a different format. For more

information about name resolution, see the Windows

documentation.

Port: Displays the SIP port on which the remote peer is listening. The default is 5060, which is the

standard port for SIP.

IP protocol: Select the IP protocol to be used for calls to this peer. Calls from this peer are accepted with all

protocols and on all ports/addresses configured in Network Interface Configuration

as described

on page 29.

If you selected MS Exchange 2007 or MS OCS2007 / Mediation Server as Peer type, set

the protocol to TCP. If you selected e-phone, set the protocol to UDP.

Domain: Enter the domain name, e.g., dialogic.com, or the IP address. The domain name must comply

with the DNS rules. The domain name entry here is only needed if the SIP peer does not use its

hostname as source domain when it places a call.