Technical data

Dialogic® Diva® SIPcontrol™ Software Configuration
Dialogic
®
Diva
®
SIPcontrol
TM
Software 1.8 Reference Guide page 26
General Configuration
You may configure the parameters shown in the graphic and explained in the table below:
Hardware
description:
Displays the installed Dialogic
®
Diva
®
Media Board. This entry is predefined by the system and
cannot be changed.
PSTN interface
number:
Displays the number of the CAPI controller. The number is set automatically by the system.
Name: Displays the name of the installed Dialogic
®
Diva
®
Media Board. The name may be modified in
order to display the purpose of the interface or the name of the PBX it is connected to.
Address map
inbound:
Select the name of a regular expression list to be applied on incoming calls on this interface. See
Address Map Configuration
on page 39 for more information about setting up a regular expression
list. If you upgraded from Dialogic
®
Diva
®
SIPcontrol
TM
Software version 1.5 or 1.5.1, an address
map is automatically generated here to provide the same number processing behavior in Diva
SIPcontrol software version 1.8 as in former Diva SIPcontrol software versions. If you used regular
expressions in Diva SIPcontrol software version 1.5.1, they will be included in this address map as
well, unless they cannot be converted to the new scheme. In this case, the entry <Use Windows
Registry values> is available. The Diva SIPcontrol software will then use the regular expressions
defined in the registry keys that were used by Diva SIPcontrol software 1.5.1.
Regular expressions may be used to add or remove dial prefixes required by a PBX or to rewrite
public phone numbers of different number ranges into a common format. See the Examples
on
page 54 for more information.
Address map
outbound:
Select the name of a regular expression list to be applied on outgoing calls on this interface. See
Address Map Configuration
on page 39 for more information about setting up a regular expression
list. If you upgraded from Dialogic
®
Diva
®
SIPcontrol
TM
Software version 1.5 or 1.5.1, an address
map is automatically generated here to provide the same number processing behavior in Diva
SIPcontrol software version 1.8 as in former Diva SIPcontrol software versions. If you used regular
expressions in Diva SIPcontrol software version 1.5.1, they will be included in this address map as
well, unless they cannot be converted to the new scheme. In this case, the entry <Use Windows
Registry values> is available. The Diva SIPcontrol software will then use the regular expressions
defined in the registry keys that were used by the Diva SIPcontrol software 1.5.1.
Regular expressions may be used to add or remove dial prefixes required by a PBX or to rewrite
public phone numbers of different number ranges into a common format. See the Examples
on
page 54 for more information.