Technical data

ManualsBrandsDialogic ManualsAdapterDiva Pro PC

Dialogic® Diva® SIPcontrol™ Software Configuration

Dialogic

Diva

SIPcontrol

Software 1.8 Reference Guide page 25

Configuration Tips and Hints

• Changes to the configuration will only take effect after you click Save at the bottom of each configuration page.

• The settings will be lost if you close the Dialogic

Diva

SIPcontrol

software web interface without having

saved the configuration at the bottom of each configuration page.

• A restart of the Diva SIPcontrol software is recommended if you change the IP address or the port on which

SIPcontrol is listening. If you do not restart, the Diva SIPcontrol software will continue listening on the

previously configured port and IP address.

Note: The restart will terminate active connections.

• The names for specific configuration elements are limited to 32 alphanumeric characters and must not be

repeated, i.e., you cannot assign the same name for two SIP peers.

• The configuration session times out after 30 minutes of inactivity and a new login is required to access the

session again. If the new login screen appears when you try to save the configuration, login again and click

the "Back" button of the browser. The configuration session opens with the settings before the time out and

you can save the configuration.

• To remove the password login page, logout from the web interface and restart the Dialogic

Diva

WebConfig

service as described below. Then open Windows

Explorer, go to C:\Program Files\Diva Server\httpd\login,

and delete the login file.

• To restart the Dialogic

Diva

WebConfig service, click Start > Settings > Control Panel > Administrative

Tools. In the Administrative Tools window, select Services. In the Services window, right-click the

Dialogic Diva WebConfig service and select Restart.

• To open the online help for a specific parameter, click the parameter and a window with the help text will pop up.

PSTN Interface Configuration

This section describes the Diva SIPcontrol software's PSTN interface related settings, e.g., which lines are used

by the Diva SIPcontrol software or how Call Transfer is performed on this line. Line Parameters such as the

signalling protocols (Q.Sig, ETSI) can be configured on the Board Configuration page. For more information,

see Dialogic

® Diva® Media Board Configuration on page 17.

At least one PSTN interface must be enabled for the Diva SIPcontrol software to be able to work. Disabled PSTN

interfaces are ignored for both inbound and outbound calls. For each line, you may select a dialplan that you

can configure as described in Dialplan Configuration

on page 37.

To change the settings for the enabled interface, click the Details button on the right hand side. To open the

online help for a specific parameter, click the parameter and a window with the help text will pop up.

Note: PSTN interfaces without a binding to the CAPI service in the Dialogic

Diva

Configuration Manager are

disabled in the Diva SIPcontrol software web interface and cannot be configured.

The following configuration menus are available for each Diva Media Board

• General Configuration below

• Address Normalization

on page 27

• C

all Transfer on page 27

• Message Waiting Indication on page 28