Technical data

Dialogic® Diva® SIPcontrol™ Software Configuration
Dialogic
®
Diva
®
SIPcontrol
TM
Software 1.8 Reference Guide page 24
CHAPTER 5
Dialogic
®
Diva
®
SIPcontrol™ Software Configuration
This chapter provides configuration tips and hints, it includes general information about each configuration, and
it gives an overview of the configurable Diva SIPcontrol parameters. The configuration of the Dialogic
®
Diva
®
Media Boards is described in Dialogic
® Diva® Media Board Configuration on page 17.
The Dialogic
®
Diva
®
SIPcontrol
TM
Software can be configured via the Diva SIPcontrol software web interface.
To open the Diva SIPcontrol software web interface:
1. Click Start > Programs > Dialogic Diva > SIPcontrol Configuration. By default, the access to the web
interface is only allowed from localhost (127.0.0.1) and by default, the port number to which the server is
listening is set to 10005.
2. If you need to access the configuration via remote access, you must set a password. To do so, open the
main configuration web interface locally and click Password on the left hand side under Configuration.
Enter a minimum 7 digit long password and confirm it. Click Save to make the new password active.
3. If necessary, open the port in the local firewall settings.
To do so:
• Click Start > Settings > Control Panel > Windows Firewall.
• In the Windows Firewall dialog box, click the Exceptions tab and click Add Port....
• In the Add a Port dialog box, enter a name, e.g., Diva SIPcontrol, and enter the port number 10005.
Select TCP as protocol and click OK to close the dialog box.
Now you may access the Diva SIPcontrol software web interface on any of the IP addresses of the computer
where SIPcontrol is installed, and configure the settings according to your needs. The Diva SIPcontrol software
configuration is divided into the following sections:
• PSTN Interface Configuration on page 25
• Network Interface Configuration
on page 29
• SIP Peer Configuration
on page 30
• Routing Configuration on page 34
• Dialplan Configuration
on page 37
• Address Map Configuration
on page 39
• C
ause Code Mapping Configuration on page 41
• Codec Configuration
on page 42
• Registrar Configuration on page 43
• S
ystem Settings on page 44
Mandatory configurations are:
1. Choose and enable one network interface.
2. Create and enable one SIP peer.
3. Create and configure one route for PSTN to SIP calls and another route for SIP to PSTN calls.
Before you start configuring, you might want to take a look at the Configuration Tips and Hints on page 25 that
include useful information for the configuration.