Installation manual

GFI FaxMaker
1 Installing fax devices |9
13. Check that the settings match your setup. If you did not make any configuration changes (i.e. you have left all settings
as default), click Apply and close the Brooktrout Configuration tool. If you need configuration assistance, you can refer to
the help included in the configuration tool.
NOTES
1. If the drivers do not work immediately when you start the GFI FaxMaker Fax Server or some lines refuse to send or
receive, please reboot the computer.
2. If an analog board refuses to dial out, make sure that the Tone Dialing option is enabled for the line in the GFI
FaxMaker Configuration > Lines/Devices node.
3. If using multiple Brooktrout boards in one chassis, make sure that they are of the same type. Having different
Brooktrout boards in one chassis is not a supported setup. Also make sure that the rotary switch on the Brooktrout
boards are setup in as sequential numbers starting from 2. I.e.: Module 1 rotary switch set to 2, Module 2 rotary switch
set to 3, etc...
1.3.2 Troubleshooting Brooktrout cards
To troubleshoot any hardware installation issues, download the Brooktrout diagnostics software from Dialogic
Technology and ensure the card is installed properly. If the card is not recognized or not running, contact Dialogic
Technology technical support.
Screenshot 8: Brooktrout diagnostics software
1.4 Installing Sangoma fax devices
This topic explains how to install Sangoma devices on your GFI FaxMaker server.