Installation manual

GFI FaxMaker
1 Installing fax devices |19
1.10 Installing the Brooktrout SR140 (FoIP)
The Brooktrout SR140 is a software-only Fax over IP (FoIP) solution from Dialogic Technology.
NOTES
To use the Brooktrout SR140 (FoIP) software, you must have both a license from Dialogic Technology, activated as
outlined below and a GFI FaxMaker license key that is enabled for Brooktrout SR140 usage. To obtain an SR140
usage license from GFI, contact [e-mail].
The Brooktrout TR1034 (Boston) / SR140 driver setup contains drivers that are made by Dialogic Technology,
however Dialogic Technology relies on vendors to distribute them.
To install the Brooktrout SR140 follow these steps:
1. Go to Start > Programs>GFIFaxMaker > GFI FaxMaker Configuration Wizard.
2. Proceed through the wizard until the Choose yourfaxhardware screen. Select Brooktrout byDialogic and click
Next to start the driver setup wizard.
Screenshot 16: Selecting the Brooktrout SR140 driver
3. Run the wizard to install the Brooktrout drivers.
4. On completion, run the Brooktrout License Managerfrom the Start menu to activate the Brooktrout SR140 license.
Click Activate... to launch the License Activation Wizard and proceed with the wizard to request and activate license.
5. Open the Brooktrout Configuration Tool. from the Start menu to configure FoIPsettings. to match your setup. For
more information refer to the documentation available in the Help.
6. From the Start menu open the FaxMaker Brooktrout Configuration GUIto confirm that you have a valid SR140 usage
license both from Dialogic Technology and GFI. If the tool indicates that Brooktrout SR140 is not licensed and/or not
installed, ensure that the Brooktrout license is activated and that the Brooktrout Boston Host service is started from the