User guide

BROOKTROUT CONFIGURATION FILES

Configuration Parameters

for T1 ISDN Ports

FALSE = Requests that the system puts all the B-channels in service as soon

as the D-channel is in service.

TRUE = Requests that the system waits for the network to specifically enable

each B-channel on the trunk before allowing the application to use a B-channel.

Default value: Depends on the value set in the switch_type parameter.

wait_for_conn_ack

Specifies a Boolean value that determines whether the system waits for the network to

acknowledge a connect request before notifying the application that a call has been

answered. Set the parameter as follows:

FALSE = Specifies that the system does not wait for the network to

acknowledge a connect request before advancing an incoming call to the

connected state.

TRUE = Requests the system to wait for the network to acknowledge a connect

request before advancing an incoming call to the connected state.

Default value: FALSE

Configuration Parameters

for T1 RBS Ports

did_offset

Specifies a value that defines the number of digits to remove from the beginning of the

string of DID digits received from the network. Valid values are:

0 = Does not remove any DID digits

1 - 63 = Specifies the number of digits to remove

Range: 0 through 63

Default value: 0

did_timeout

Specifies a value that defines the maximum timeout allowed before processing the call

after assuming receipt of the last DID digit. Valid values are:

0 = Indicates no waiting time

1 - 20 = Specifies the number of seconds to allow after receiving the last DID

digit before processing the call

Unit: second

Range: 0 through 20

Default value: 10 (used when the API does not find another value for this parameter)

flash_hook_

duration

Specifies a value for the duration of a flash hook signal. This parameter defines the

amount of time to place the line on hook (loop current dropped) during a flash hook.

Set the value in units of 10 ms.

Unit: 10 ms

Range: 1 - 500

Default value: 50

line_build_out

Specifies one of the following values that defines the length of the telephony cable