User guide

FAX BOARDS AND FAX DRIVERS INSTALLATION
64
Configuration Parameters
for BRI Ports
number.
USER_NOT_SCREENED Indicates that the port provides the calling party
number without validating it.
USER_VERIFICATION_FAILED Indicates that the port failed to validate the
calling party number.
USER_VERIFICATION_PASSED Indicates that the port provided the calling
party number and passed a successfully validated number to the called party.
Note: Set the parameter to USER_NOT_SCREENED when connected to a public
network.
Default value: USER_NOT_SCREENED
send_dialcomplete
Specifies a Boolean value that determines whether the system sends a dial complete
informational element (IE) on outbound calls. Set the parameter as follows:
FALSE = Indicates that the port does not send a dial complete IE message on
outbound calls.
TRUE = Requests the system to send a dial complete IE message on
outbound calls.
Default value: TRUE
spid
Specifies a value that indicates a number assigned as a service profile identifier
(SPID). The USA sometimes uses this identifier but European nations do not. Leave
the field blank unless the service requires an identifier. Valid values are:
Unit: character
Range: 1 - 15 (_ECC_MAX_ANI_LENGTH)
Default value: Blank
transfer_variant
Specifies the transfer method that the network (refer to the vendor specifications for
your switch) runs for call transfers, or disables call transfer. Valid values are:
NONE = Disables call transfer
ETSI_EXP_LINK = Specifies an ETSI transfer with explicit linkage
ETSI_IMP_LINK = Specifies an ETSI transfer with implicit linkage
If the API cannot perform implicit linkage because there are more than two calls on
the D-channel, the API performs explicit linkage.
NTT = Specifies a JATE active redirecting transfer
NTT_MP = Specifies a JATE active redirecting transfer for a point to multipoint
configuration
Default value: ETSI_IMP_LINK
wait_for_conn_ack
Specifies a Boolean value that determines whether the system waits for the network
to acknowledge a connect request before notifying the application that a call has
been answered. Set the parameter as follows:
FALSE = Specifies that the system does not wait for the network to
acknowledge a connect request before advancing an incoming call to the
connected state.
TRUE = Requests the system to wait for the network to acknowledge a