User guide

FAX BOARDS AND FAX DRIVERS INSTALLATION
58
Port Configuration
Parameters
Use this parameter in conjunction with the fractional_start_channel parameter.
Note: Set this parameter to -1 when not using fractional channels.
Setting this parameter to 0 makes zero B-channels available.
Valid values are:
-1 = Indicates that a fractional port is not in use
0 - 29 = Indicates the number of available E1 channels on the fractional port
0 - 22 = Indicates the number of available T1 ISDN channels on the fractional
port
0 - 23 = Indicates the number of available T1 RBS channels on the fractional port
Range: -1, 0 - 29
Default value: -1
wait_for_service_timeout
Specifies a value that indicates the amount of time to wait for a trunk to come into
service before returning an error when placing an outbound call. If this timeout expires,
the outbound call fails. If the trunk comes into service before this timeout expires, the
system places the call normally.
Unit: second
Range: 0 - 10,000
Default value: 10
Configuration Parameters for
Analog Ports
caller_id
Specifies a Boolean value that indicates whether detection of V.23-based caller ID
has been enabled. Set the parameter as follows:
FALSE = Indicates that the port has disabled detection of V.23-based caller
ID.
TRUE = Indicates that the port has enabled detection of V.23-based caller
ID.
Default value: TRUE
country
Specifies the name of the file that matches a binary file containing the country
coefficients to use for the port.
Range: Maximum of 256 characters (_MAX_PATH)
Default value: None
flash_hook_duration
Specifies a value that defines the duration of a flash hook signal. This field defines
the amount of time to place the line on hook during a flash hook.
Unit: 10 ms
Range: 1 - 500
Default value: 50