User guide

FAX BOARDS AND FAX DRIVERS INSTALLATION
54
Keyword Description
mode after having missed the initial CED tone.
Value Type
decimal
Default value
1
v34_enable
Enables (1) or disables (0) V.34 fax modulation capability, if the hardware and firmware support
it.
Value Type
decimal
Default value
1
width_res_behavior
Specifies the action taken as a result of page width or resolution mismatches on fax
transmission. Does not affect fax reception. Scaling the fax is not available for all combinations
of resolution mismatches.
0 = Terminate the call.
1 = Horizontally and vertically scale the fax.
2 = Truncate the page. TruFax boards always truncate or pad the page.
Value Type
decimal
Default value
1
Configuration File: callctrl.cfg
The call control configuration file is an ASCII file. It contains general PCM configuration parameters for all telephony
hardware units and static telephony connections to be formed for all modules as well as the IP interface parameters.
The parameters below apply to all the supported TR1034 or TruFax boards and to SR140 software in VSI-FAX.
Global options
l3l4_trace
l4l3_trace
api_trace
none = Does not perform a trace operation (default value).
error = Detects errors and stores them in the specified trace_file.
warning = Detects warnings and stores them in the specified trace_file.
basic = Stores a simplified trace in the specified trace_file.