User guide

FAX BOARDS AND FAX DRIVERS INSTALLATION
38
The setup has to run these commands to allow loading the Dialogic deamon:
chcon -t textrel_shlib_t /usr/sys/boston/lib/4.1/bostlib_mt.so
chcon -t textrel_shlib_t /usr/sys/boston/lib/4.1/brkth323_mt.so
chcon -t textrel_shlib_t /usr/sys/boston/lib/4.1/brktsip_mt.so
chcon -t textrel_shlib_t /usr/sys/boston/lib/4.1/bostvb.so
Can the setup run the above commands ? (y/n) [y] :
When you see the above prompt, answer yes.
Can the setup run the above commands ? (y/n) [y] : y
If you answer no, the installation will abort after displaying the following message:
Can the setup run the above commands ? (y/n) [y] : n
The setup will abort because the listed libraries have not text relocation
attributes.
9. When the Brooktrout Boston Driver has been installed on your machine, the list of available boards appears:
Select the Dialogic Brooktrout board or SR140 Fax Software to configure:
1) TR1034 - T1 - 24 channels
2) TR1034 - T1 - 16 channels
3) TR1034 - T1 - 8 channels
4) TR1034 - T1 - 4 channels
5) TR1034 - E1 - 30 channels
6) TR1034 - E1 - 20 channels
7) TR1034 - E1 - 16 channels
8) TR1034 - E1 - 10 channels
9) TR1034 - E1 - 8 channels
10) TR1034 - E1 - 4 channels
11) TR1034 - Analog - 8 channels
12) TR1034 - Analog - 4 channels
13) TR1034 - Analog - 2 channels
14) TruFax - Analog - 2 channels
15) TruFax - Analog - 1 channel
16) TR1034 - BRI - 4 channels
17) TR1034 - BRI - 2 channels
18) TruFax - BRI - 4 channels
19) TruFax - BRI - 2 channels
20) SR140 - IP - The number of channels depends on the license
q) Quit
Select your board type.
10. Select the circuit type to use. Here are the options that may be available to you depending on your board type:
0 Robbed-bit (RBS)
1 ISDN (PRI)
2 SIP (IP)
3 H323 (IP)
q Quit
11. Select your Brooktrout board module number.
Note
The module number is set on the board. The default module number is 2, and it is most likely to be used if
you have only one board installed.
12. If you have selected SIP or H323 above, enter the information needed to configure the IP interface of the
board:
board ip address
board ip mask
board ip gateway
board ip broadcast
13. To configure the SIP stack, enter the SIP default gateway.
To configure the H323 stack, enter the H323 default gateway and optionally your H323 gatekeeper ip address
if you want to use it.