User guide

INSTALLING BROOKTROUT DRIVERS ON WINDOWS

Fax board in PSTN mode configuration

After the steps described in Configuring the Brooktrout driver for TR1034, TruFax boards or SR140 (page 18),

continue with the steps below if you own a fax board with which you will perform PSTN physical faxing only.

1. If your fax board supports Fax over IP, the Configure IP Stack dialog box displays when the Brooktrout

Configuration Tool is launched. Select None so that you don't use Fax over IP and instead perform only

physical faxing, and click OK.

2. The Brooktrout Configuration Tool is launched to allow you to configure your board. Click on the BTCall

Parameters (All boards) node in the tree view to configure BTCall Parameters.

• Check that the Country Telephony Parameter File field is set to

%ProgramFiles%\brooktrout\config\BT_CPARM.cfg.

• Set the Country field to your country (if you reside in a European country, select European

Community)