User guide

FAX BOARDS AND FAX DRIVERS INSTALLATION

• In the case of an upgrade, you can change the option selection. Leave the screen as is with Install/Re-

install and Keep actual boards configuration options selected to keep your configuration and simply

update it. Be aware that selecting Reset actual boards configuration clears all your configurations and

performs a fresh installation of the Brooktrout drivers. Click Next to launch the Brooktrout TR1034-

SR140 drivers installation.

• In the case of a fresh installation, the options are greyed. You can only click Next to launch the

Brooktrout TR1034-SR140 drivers installation.

4. You can see a progress bar during the file copy. Various programs are launched (Brooktrout setup, command

line). Do not cancel any of these programs.

5. Once the file copy is finished, the following screen is displayed:

• If you have already run the Brooktrout Configuration Tool, keep the first option selected and click Next

if you want to change your board configuration. Uncheck the first option if you do not need to change

the board configuration.

• If this is the first time that you launch the Brooktrout Configuration Tool, the appropriate options are

selected and greyed, click Next to proceed with the configuration.

When the installation is finished, the Brooktrout Configuration Tool is launched. The next steps are different

depending on whether you are setting up a fax board or SR140 software solution and whether the fax board you own

(if any) supports Fax over IP and you want to configure Fax over IP or not. There are three cases:

You own a fax board and want to perform physical faxing in PSTN mode only with it (no Fax over IP even if

available). Refer to Fax board in PSTN mode configuration

(page 23).

You own a fax board that supports Fax over IP and you want to perform both Fax over IP and physical faxing

in PSTN mode. Refer to Fax board with Fax over IP configuration

(page 25).

You want to set up Brooktrout SR140 solution for Fax over IP (software only). Refer to SR140 configuration on

Windows (page 29).

Proceed with the steps that correspond to your scenario.